Apparatus, Petrillo, Rescues, SVI

Special Delivery: SVI Trucks Delivers Heavy Rescue to Sherman (TX) Fire-Rescue

Issue 8 and Volume 24.

Sherman (TX) Fire-Rescue was running a rescue truck on a Ford F-450 chassis with a Fraser box on the back that could only carry a minimal amount of rescue equipment because of its limited gross vehicle weight rating (GVWR).

As a work-around, Sherman had four enclosed rescue trailers that carried its swift water equipment, high- and low-angle rescue gear, confined space equipment, and trench/collapse equipment. But, the department wanted to put all that gear on a single vehicle, so it began the search for a heavy rescue truck.

“It was about a four-year process of trying to get a heavy rescue for the department,” says Thomas Brown, Sherman Fire-Rescue’s division chief. “The department had gone before the city council three times but was not able to get funding. When I got involved in the process, I did more research and was able to show the city manager that we were looking to get a vehicle with a 20- to 25-year service life, and it wouldn’t necessarily be on the road every day because the vehicle would run on demand. He told us to go out and find the right truck.”

Brown says the truck committee spent another three months searching for the right truck, talking with vendors, and looking at existing rescue trucks. “We looked at both new rescues and vehicles that had been in service for a while because our fleet department wanted to know how well the bodies were built and held up,” he notes. “Then we sat down and spec’d the truck and gave the specs to three vendors. The city chose SVI Trucks to build the heavy rescue for $612,000.”

SVI Trucks built this heavy rescue for Sherman (TX) Fire-Rescue on a Spartan Metro Star LFD chassis and cab with a 20-inch raised roof and a 22-foot aluminum body.

1 SVI Trucks built this heavy rescue for Sherman (TX) Fire-Rescue on a Spartan Metro Star LFD chassis and cab with a 20-inch raised roof and a 22-foot aluminum body. (Photos courtesy of Metro Fire Apparatus Specialists.)

The wheelbase on the SVI heavy rescue for Sherman is 231 inches, the overall length is 36 feet 8 inches, and the overall height is 11 feet.

2 The wheelbase on the SVI heavy rescue for Sherman is 231 inches, the overall length is 36 feet 8 inches, and the overall height is 11 feet.

Sherman’s heavy rescue carries a Resolve Specialty Products SpaceSaver™ two-position SCBA fill station.

3 Sherman’s heavy rescue carries a Resolve Specialty Products SpaceSaver™ two-position SCBA fill station.

THE HEAVY RESCUE

Bob Sorensen, vice president of SVI Trucks, says the heavy rescue SVI built for Sherman is on a Spartan Metro Star LFD chassis and cab with seating for four firefighters, H.O. Bostrom seats, a 20-inch raised roof, and 22-foot aluminum body. The rig is powered by a Cummins 450-horsepower (hp) L9 engine and an Allison 3000 EVS automatic transmission and has a wheelbase of 231 inches, an overall length of 36 feet 8 inches, and an overall height of 11 feet.

The truck has an Onan 15-kW power takeoff (PTO) generator, a Bauer air bottle cascade system, a Resolve Specialty Products (RSP) SpaceSaver™ two-position self-contained breathing apparatus (SCBA) fill station, a Hannay electric reel with 200 feet of cable, Whelen LED warning lights, Whelen Pioneer PFS2 LED scene lights, OnScene Solutions LED compartment lights, and a Roto-Ray warning light.

“Sherman had a lot of equipment that they wanted to go on the truck,” Sorensen observes. “They wanted to get away from using the small rescue truck and multiple trailers and put their equipment on a single vehicle so they would have everything they needed right at hand. So, we designed the rescue truck around the equipment they wanted to carry.”

specs

SVI Trucks Heavy Rescue for Sherman (TX) Fire-Rescue

  • Spartan Metro Star LFD chassis and cab with 20-inch raised roof
  • 22-foot aluminum body
  • 36-foot 8-inch overall length
  • 11-foot overall height
  • 231-inch wheelbase
  • Cummins 450-hp L9 engine
  • Allison 3000 EVS automatic transmission
  • Onan 15-kW PTO generator
  • Four-bottle cascade air system
  • Resolve Specialty Products SpaceSaver™ two-position SCBA fill station
  • OnScene Solutions aluminum heavy-duty cargo slides
  • Custom mounts for TNT rescue tool system
  • Hannay 200-foot electric cable reel
  • Whelen Pioneer PFS2 LED scene lights
  • Whelen LED warning lights
  • OnScene Solutions LED compartment lights
  • Roto-Ray warning light

Price without equipment: $612,000

EQUIPMENT SPECIFICITY

Brian Cudaback, apparatus manager for Metro Fire Apparatus Specialists, who sold the heavy rescue to Sherman, says that one of the most important considerations when building a rescue truck is getting a list of the specific equipment the department wants to carry. “At the preconstruction meeting, you want to work with a fire department that has a good idea of the equipment they will carry and where they want it located on the truck,” Cudaback says. “Sherman was very good in that regard. And, SVI is excellent at helping a customer figure out where equipment should go if they don’t have a specific location in mind. We can suggest locations where we have done prior placements on other rescue trucks.”

One of the two transverse compartments on the rescue holds Sherman’s Paratech rescue struts.

4 One of the two transverse compartments on the rescue holds Sherman’s Paratech rescue struts.

This slide-out compartment tray holds Sherman’s rescue saws.

5 This slide-out compartment tray holds Sherman’s rescue saws.

Compartments that are above chest height have slide-out, drop-down trays.

6 Compartments that are above chest height have slide-out, drop-down trays.

This compartment has a shelf with a power strip to keep all of the rescue’s batteries fully charged.

7 This compartment has a shelf with a power strip to keep all of the rescue’s batteries fully charged.

A compartment over the rear axle holds seven 5⁄8-inch thick and seven ½-inch-thick sheets of 4 × 8 plywood.

8 A compartment over the rear axle holds seven 5⁄8-inch thick and seven ½-inch-thick sheets of 4 × 8 plywood.

SVI built a full-width recessed tray in the extended front bumper to hold Sherman’s Holmatro EVO 4 rescue tools, a 24-inch spreader, ram, ram block, cutter, spare batteries, charger, and 110-volt outlets for the charger.

9 SVI built a full-width recessed tray in the extended front bumper to hold Sherman’s Holmatro EVO 4 rescue tools, a 24-inch spreader, ram, ram block, cutter, spare batteries, charger, and 110-volt outlets for the charger.

Brown says he was surprised when SVI requested a list of every piece of equipment that would be carried on the truck. “And, it wasn’t just a long list of the equipment,” he adds. “They wanted the brand, model number, sizes, and types of equipment—all before the precon meeting. Then at the precon meeting, they showed us CAD drawings for the entire truck and how each compartment would be laid out. If we didn’t like how it was done, they moved it around until we were satisfied. SVI put a lot of time and effort into the detail work of getting the truck right.”

department

Sherman (TX) Fire-Rescue

Strength: 86 paid firefighters (72 paramedics and 14 emergency medical technicians); five stations.

Service area: Sherman Fire-Rescue provides fire, rescue, and emergency medical services to a population of 42,000 in the 42-square-mile city of Sherman as well as in 28 square miles of contracted area in Grayson County, Texas.

Other apparatus: 2017 Pierce pumper, 1,250 gallon-per-minute (gpm) pump, 750-gallon water tank, compressed-air foam system (CAFS); 2015 Pierce pumper, 1,250-gpm pump, 750-gallon water tank, CAFS; 2009 Pierce pumper, 1,250-gpm pump, 750-gallon water tank, CAFS; 2017 Smeal 75-foot aerial ladder quint, 1,750-gpm pump, 300-gallon water tank; 2010 Pierce 95-foot aerial platform quint, 2,000-gpm pump, 300-gallon water tank; two 2017, one 2016, and one 2015 Mobile Intensive Care Units (MICUs) by Fraser on Dodge 4500 chassis; 2009 Achilles SG156 rescue boat; one battalion chief vehicle.

COMPARTMENTATION

SVI designed the Sherman heavy rescue truck with two transverse compartments in front of the rear wheels to hold the department’s Paratech rescue equipment, air bags, lumber, and technical rescue gear and a compartment above the rear axle that holds seven 5⁄8-inch-thick 4 × 8 sheets of plywood and seven ½-inch-thick 4 × 8 sheets.

Brown says that “SVI is magnificent about using all of a truck’s dead space. They located our air bottles and RSP two-position fill station under the rear stairway to the top of the truck instead of taking up space in a side compartment.” He adds, “They also built in a full-width recessed tray in the extended front bumper that holds a full complement of Holmatro EVO 4 rescue tools—a 24-inch spreader, ram, ram block, cutter, spare batteries, chargers, and 110-volt outlets for the battery chargers.” The truck also carries Sherman’s TNT Rescue hosed hydraulic tools in the R2 compartment.

Brown points out that Sherman responds to about 7,500 calls for service yearly, with 60 percent being medical calls; 20 percent fire calls; and 20 percent calls for service, false alarms, hazmat incidents, and moving vehicle accidents. “We’re very proud of our rescue truck,” he says. “The truck had been in service only two days when it made its first mutual-aid rescue of a construction worker on a two-story home who fell from the roof to the second floor, which didn’t have a staircase to it yet. Our firefighters made a rope rescue off the new truck, and we are very pleased at the way SVI set up the truck for us.”

ALAN M. PETRILLO is a Tucson, Arizona-based journalist, the author of three novels and five nonfiction books, and a member of the Fire Apparatus & Emergency Equipment Editorial Advisory Board. He served 22 years with the Verdoy (NY) Fire Department, including in the position of chief.